Filter
Top Products
12-22
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
OL-10101-02
Chapter 12 Configuring LRE
Configuring LRE Ports
To re-enable CPE toggle on the Cisco 585 LRE CPE link, use the cpe toggle [port port-id] interface
configuration command.
Configuring Syslog Export
If the syslog export feature is enabled, the switch sends the debugging messages to the LRE message
logging process and to the system message logging process.
Before enabling this feature, follow these guidelines:
• Make sure that LRE logging is enabled.
• Make sure that the console severity in the system message logging configuration is set to debugging.
For more information, see
Chapter 26, “Configuring System Message Logging.”
Beginning in privileged EXEC mode, follow these steps to enable the switch to send debugging
messages to the LRE message logging process and to the system message logging process:
To disable the syslog export feature, use the no lre syslog global configuration command. When you
enter this command, the switch sends debugging messages only to the LRE message logging process.
Beginning in privileged EXEC mode, follow these steps to specify the mode in which to log LRE events:
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify the change.
Step 6
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
lre syslog Enable the switch to send debugging messages from the LRE
logging process to the system message logging process.
Step 3
end Return to privileged EXEC mode.
Step 4
show running-config Verify the change.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Specify the LRE port to be configured, and enter interface
configuration mode.
Step 3
logging lre {event | extended | normal} Specify the mode in which to log LRE events:
• event—Log events only.
• extended—Log events and all possible parameters.
• normal—Log events and some typical parameters.
Step 4
end Return to privileged EXEC mode.