Filter
Top Products
29-34
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
OL-10101-02
Chapter 29 Configuring QoS
Configuring Standard QoS
If these values are not appropriate for your network, you need to modify them.
Beginning in privileged EXEC mode, follow these steps to modify the DSCP-to-CoS map:
To return to the default map, use the no mls qos map dscp-cos global configuration command.
This example shows how the DSCP values 26 and 48 are mapped to CoS value 7. For the remaining
DSCP values, the DSCP-to-CoS mapping is the default.
Switch(config)# mls qos map dscp-cos 26 48 to 7
Switch(config)# exit
Switch# show mls qos maps dscp-cos
Dscp-cos map:
dscp: 0 8 10 16 18 24 26 32 34 40 46 48 56
-----------------------------------------------
cos: 0 1 1 2 2 3 7 4 4 5 5 7 7
Ta b l e 29-8 Default DSCP-to-CoS Map
DSCP Values CoS Value
0 0
8, 10 1
16, 18 2
24, 26 3
32, 34 4
40, 46 5
48 6
56 7
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
mls qos map dscp-cos dscp-list to cos Modify the DSCP-to-CoS map.
For dscp-list, enter up to 13 DSCP values separated by spaces. Then enter
the to keyword.
For cos, enter the CoS value to which the DSCP values correspond.
The supported DSCP values are 0, 8, 10, 16, 18, 24, 26, 32, 34, 40, 46, 48,
and 56. The CoS range is 0 to 7.
Step 3
end Return to privileged EXEC mode.
Step 4
show mls qos maps dscp-cos Verify your entries.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.