Filter
Top Products
Contents
xxxvi
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
Redistributing Sources 45-9
Filtering Source-Active Request Messages 45-10
Controlling Source Information that Your Switch Forwards 45-11
Using a Filter 45-12
Using TTL to Limit the Multicast Data Sent in SA Messages 45-13
Controlling Source Information that Your Switch Receives 45-13
Configuring an MSDP Mesh Group 45-15
Shutting Down an MSDP Peer 45-15
Including a Bordering PIM Dense-Mode Region in MSDP 45-16
Configuring an Originating Address other than the RP Address 45-17
Monitoring and Maintaining MSDP 45-18
CHAPTER
46 Configuring Fallback Bridging 46-1
Understanding Fallback Bridging 46-1
Fallback Bridging Overview 46-1
Fallback Bridging and Switch Stacks 46-3
Configuring Fallback Bridging 46-3
Default Fallback Bridging Configuration 46-4
Fallback Bridging Configuration Guidelines 46-4
Creating a Bridge Group 46-4
Adjusting Spanning-Tree Parameters 46-6
Changing the VLAN-Bridge Spanning-Tree Priority 46-6
Changing the Interface Priority 46-7
Assigning a Path Cost 46-7
Adjusting BPDU Intervals 46-8
Disabling the Spanning Tree on an Interface 46-10
Monitoring and Maintaining Fallback Bridging 46-11
CHAPTER
47 Troubleshooting 47-1
Recovering from a Software Failure 47-2
Recovering from a Lost or Forgotten Password 47-3
Procedure with Password Recovery Enabled 47-5
Procedure with Password Recovery Disabled 47-6
Preventing Switch Stack Problems 47-8
Preventing Autonegotiation Mismatches 47-9
Monitoring Temperature 47-9
Using Ping 47-10
Understanding Ping 47-10