Filter
Top Products
3-14
Cisco TelePresence System
OL-16441-01
Chapter 3 Options for the Cisco TelePresence System 3000
Cisco TelePresence Presentation Codec
Step 16 Route the signal cables for the presentation codec using one of the following diagrams:
• For a standard CTS-3000 installation, use the following wiring diagram for the presentation codec.
Note If you have an Auxiliary Control Unit, substitute the signal cabling between the presentation codec and
the primary codec with the alternate cabling for the Auxiliary Control Unit.
Figure 3-12 Cable Routing for Presentation Codec and Auxiliary Control Unit
204195
12
12
10/100 NETWORK PORTSRESETSERIAL PORTS
Microphone
Speaker
Primary Codec
Projector
Presentation Codec
Auxiliary Video Out
Camera
IP Phone
Primary
Codec
Signal
Network
Left Right
Auxilliary
Document Camera
Left Codec
Right Codec
Center
Display
Auxiliary Video In
Primary Codec Signal
Auxiliary Video In
Video out
Video In
Serial
Auxiliary Control Unit (Optional)
Serial 2
Serial 1
Ethernet 1
Ethernet 2