Cisco Systems 3700 Series Network Router User Manual


 
10
Closing a Chassis of 2-RU Height with Removable Cover
Perform this procedure with electrical power to the router turned OFF, with network interface cables disconnected, and with
the router removed from its mounting rack.
Step 1 Hold the cover at a 45-degree angle, engage the hinge, and lower the cover onto the chassis. (See Figure 11.)
Step 2 Reinstall the cover screws (typically five or six, depending on the router model).
Step 3 If your router has a blank cover plate in the upper right network-module slot, and displays the message LOOSEN
SCREW TO REMOVE COVER, reinstall the captive screw at the left edge of the blank cover.
Figure 11 Replacing the Cover on a Chassis of 2-RU Height
Step 4 Install the router in a rack or on a desktop, and connect power and interface cables.
Step 5 Power ON the router, and refer to the “Verifying AIM Installation” section on page 12.
Observe the following warning if your Cisco router uses DC power:
Warning
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate power by
moving the handle of the circuit breaker to the ON position. To see translations of the various warnings that appear
in this publication, refer to the Regulatory Compliance and Safety Information document that accompanied this
device.
72852
1
2