Filter
Top Products
2-786
Catalyst 6500 Series Switch Command Reference—Release 7.6
78-15328-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
show mls
show mls
To display MLS Layer 3 packet information in the MLS-based Catalyst 6500 series switches, use the
show mls command.
show mls [ip | ipx] [mod]
Syntax Description
Defaults The default displays both IP and IPX MLS information.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines If you enter any of the show mls commands on Catalyst 6500 series switches without IP or IPX MLS,
one of these warning messages is displayed:
Multilayer switching not supported on feature card.
or
IPX Multilayer switching not supported on feature card.
If you place the MSFC on a supervisor engine installed in slot 1, then the MSFC is recognized as
module 15. If you install the supervisor engine in slot 2, the MSFC is recognized as module 16.
This command is not supported on switches configured with the Supervisor Engine 2 with Layer 3
Switching Engine II (PFC2).
Examples These examples show the display if you enter the show mls commands on a switch configured with the
Supervisor Engine 1 with Layer 3 Switching Engine WS-F6K-PFC:
Console> (enable) show mls
Total Active MLS entries = 0
Total packets switched = 0
IP Multilayer switching enabled
IP Multilayer switching aging time = 256 seconds
IP Multilayer switching fast aging time = 0 seconds, packet threshold = 0
IP Flow mask: Full Flow
Configured flow mask is Destination flow
Active IP MLS entries = 0
Netflow Data Export version: 8
Netflow Data Export disabled
Netflow Data Export port/host is not configured
Total packets exported = 0
ip (Optional) Specifies IP MLS.
ipx (Optional) Specifies IPX MLS.
mod (Optional) Number of the MSFC; valid values are 15 and 16.