Filter
Top Products
2-862
Catalyst 6500 Series Switch Command Reference—Release 7.6
78-15328-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
show port capabilities
Table 2-63 describes the possible fields (depending on the type of port queried) and the values in the
show port capabilities command output.
Table 2-63 show port capabilities Command Output Fields
Field Description
Model Module model number.
Port Module number and port number.
Type
1
1. This field will change depending on the module configuration.
Port type (1000BASE-SX or 100BASE-FX).
Speed
1
Speed setting for the port (auto, 10, 100, 1000).
Duplex Duplex mode (half, full, auto).
Trunk encap type
2
2. This field is applicable to the 48-port 10/100BASE-TX switching services-configured module and the 24-port FXS
analog station interface services-configured module.
Trunk encapsulation type (ISL, 802.1Q, 802.10, or no).
Trunk mode
2
Trunk administrative status of the port (on, off, auto, desirable,
nonegotiate, or no).
3
3. “No” means that the port is trunk incapable.
Channel Status of which ports can form a channel group. The ports are shown in
mod/port format. For example, 3/1-2 indicates module 3, ports 1 and 2.
Also, any ports in range [mod/1-mod/high_port] or no ports may be
indicated.
Broadcast
suppression
Percentage of total available bandwidth that can be used by broadcast
traffic (0–100).
Flow control Flow-control options you can set (receive-[off, on, desired], send-[off, on,
desired], or no).
Security Status of whether port security is enabled (yes, no).
Membership Method of membership assignment of a port or range of ports to a VLAN
(static, dynamic).
Fast start Status of whether the spanning tree PortFast-start feature on the port is
enabled (yes, no).
QOS scheduling Status of whether the port supports QoS scheduling (yes, no).
QOS classification Status of whether the port supports QoS classification (yes, no).
CoS rewrite Status of whether the port supports CoS rewrite (yes, no).
SPAN SPAN type supported.
ToS rewrite Status of whether the port supports ToS rewrite (IP-Precedence).
UDLD Status of whether the port is UDLD-capable or not.
Inline power
2
Status of whether the port supports inline power (yes, no).
Auxiliaryvlan
2
Status of whether the port supports voice VLANs (yes, no).
Link debounce
timer
Status of whether the port supports debounce timer (yes, no).