Filter
Top Products
2-853
Catalyst 6500 Series Switch Command Reference—Release 7.6
78-15328-01
Chapter 2 Catalyst 6500 Series Switch and ROM Monitor Commands
show port
Related Commands set port disable
set port enable
show port status
Good-bytes Total number of octets in frames with no error.
Short-event Number of short events received.
InlinePowered
1
InlinePowered for Admin (auto, on, off), Oper (on, off, denied), and
Detected (yes, no).
PowerAllocated
1
PowerAllocated for Watts (values displayed as Watts measurement) and
Volts (values displayed as Volts measurement).
Age-Time
1
Age timeout setting for the port.
Age-Left
1
Age timeout remaining for the port.
Maximum-Addrs
1
Maximum number of secured MAC addresses on the port.
CallManagerState
1
Operational state of the voice port (Not Registered, Registered, Up, Down,
and Alarm).
NoiseRegen
3
Status of whether noise regeneration is enabled for the port.
NonLinear
3
Status of whether nonlinear processing is enabled for the port.
Comp-Alg
3
Type of compression algorithm used (for example G.711, G.723, and G.729).
IP-address
3
IP address associated with the port.
Netmask
3
Netmask associated with the port.
MAC-Address
3
MAC address associated with the port.
Call-Manager-IP
3
Cisco CallManager IP address associated with the port.
DHCP-Server-IP
3
DHCP server IP address associated with the port.
DNS-Server-IP
3
DNS server IP address associated with the port.
TFTP-Server-IP
3
TFTP server IP address associated with the port.
1. This field is applicable to the 48-port 10/100BASE-TX switching services-configured module.
2. This field changes according to the system configuration.
3. This field is applicable to the 8-port T1/E1 DSP services-configured module.
Table 2-60 show port Command Output Fields (continued)
Field Description