Filter
Top Products
2-49
Cisco Aironet 1550 Series Outdoor Mesh Access Point Hardware Installation Guide
OL-24247-01
Chapter 2 Installing the Access Point
Powering the Access Point
Step 8 Slide the liquid-tight adapter towards the access point, and screw the threaded end of the adapter into the
access point, and hand-tighten.
Step 9 Use an adjustable wrench, a 22-mm socket, or a Sealcon S-2200-WR wrench to tighten the threaded end
of the adapter to 6 to 7 ft lbs (8.1 to 9.5 Nm).
Step 10 Use an adjustable wrench and tighten the round end of the adapter to 2.7 to 3.2 ft lbs (3.66 to 4.34 Nm).
Step 11 Ensure that the antennas are connected to the access point before you apply power to the access point.
Step 12 Route your Ethernet cable, and cut off any excess cable.
Step 13 Install an RJ-45 connector on the unterminated cable end, and insert it into the power injector. For typical
installation components, see Figure 2-2.
Step 14 Turn on power to the power injector.
AC Power Cords for Cisco Aironet 1550 Series Outdoor Mesh Access Points
The Cisco Aironet 1550 series outdoor mesh access point supports these AC power cord options:
• 40-ft (12.2-m) power cord (AIR-CORD-R3P-40NA=) for light pole installations in the US and
Canada.
• 40-ft (12.2-m) power cord (AIR-CORD-R3P-40UE=) for light pole installations in the European
Union.
• 4-ft (1.2-m) streetlight power tap adapter (AIR-PWR-ST-LT-R3P=) for light pole installations in the
US and Canada.
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring.
Statement
1022
Caution Prior to connecting or disconnecting a power cord, you must remove AC power from the power cord
using a suitable service disconnect.
Note European Union users need to install a country-specific plug to the blunt cut end of the cable assembly.
Note In all installations, the detachable power cord (pluggable Type B) must be an approved type acceptable
to the authorities in the country where the unit is sold, and must meet all local and national electrical
codes.