Filter
Top Products
1-5
C7200 VSA (VPN Services Adapter) Installation and Configuration Guide
OL-9129-02
Chapter 1 Overview
Supported Standards, MIBs, and RFCs
Performance
Table 1-2 lists the performance information for the VSA.
Supported Standards, MIBs, and RFCs
This section describes the standards, Management Information Bases (MIBs), and Request for
Comments (RFCs) supported on the VSA. Requests for Comments (RFCs) contain information about
the supported Internet suite of protocols.
Standards
• IPSec/IKE: RFCs 2401-2411, 2451
MIBs
• CISCO-IPSEC-FLOW-MONITOR-MIB
• CISCO-IPSEC-MIB
• CISCO-IPSEC-POLICY-MAP-MIB
To obtain lists of supported MIBs by platform and Cisco IOS release, and to download MIB modules,
go to the Cisco MIB website on Cisco.com at the following URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
RFCs
• IPSec/IKE: RFCs 2401-2411, 2451
2. Number of tunnels supported varies based on the total system memory installed.
3. On the NPE-G2, the minimum memory requirement is 1 GB of memory.
Table 1-2 Performance for VSA
Cisco Router Throughput
1
2
1. As measured with IPSec 3DES or AES Hashed Message Authentication Code (HMAC)-SHA-1 on 1400-byte packets.
Performance varies depending on the number of modules, bandwidth, traffic volume, Cisco IOS software release, and so
forth.
2. Using Cisco 12.4(4)XD3 fc2 image. Performance varies by Cisco IOS software release.
Description
Cisco 7200VXR
series routers
with the
NPE-G2
processor
Performance to
900 Mbps
encrypted
throughput
Cisco IOS release: 12.4(4)XD3 fc2
7200VXR/NPE-G2/VSA, 1GB system memory
3DES/HMAC-SHA or AES/HMAC-SHA, preshared with no
IKE-keepalive configured