Filter
Top Products
1-7
C7200 VSA (VPN Services Adapter) Installation and Configuration Guide
OL-9129-02
Chapter 1 Overview
LEDs
LEDs
The VSA has one LED, as shown in Figure 1-3.
Table 1-4 System is in Run-time Operation
Condition System is Configured
Inserting the VSA The VSA runs in power-off, but you need to perform a system reload or a
reset to bring the VSA up.
CLI Enabling VSA Not supported.
CLI Disabling VSA Hw-module slot 0 shutdown—Not supported.
[no] crypto engine [slot | accelerator] 0—See Table 1-5
Removing VSA You must enter a disabling CLI (see Table 1-5) before removing the card
to avoid damaging the hardware.
Table 1-5 crypto engine Command
Command Description of VSA Behavior
Crypto engine slot 0
Crypto engine accelerator 0
Note The VSA can only be inserted in slot 0
(the I/O controller slot).
This allows the VSA to come up and be registered
as a crypto engine with the system.
If you just performed this configuration and the
VSA is currently disabled, reload or reset the
system to bring the VSA up.
Note The current crypto engine will be still
running, and the VSA will take over after
the next system reboot.
No crypto engine slot 0
No crypto engine accelerator 0
These CLIs will disable the VSA. This is a
configuration setting, so the VSA will remain
disabled until you remove this configuration and
system reloads or resets.