Filter
Top Products
1
1-1 Fiery on the network
This chapter summarizes the stages in setting up the Fiery, and includes diagrams that
refer you to other chapters or other manuals for completing your installation. Check
those references to find the information you need quickly.
Fiery on the network
When the Fiery is connected to a network, it behaves as a networked PostScript
printer. The built-in Ethernet interface on the printer supports the following network
protocols (rules that enable computers on a network to communicate with each other):
• AppleTalk
• TCP/IP (the lpd, nbt, and http protocols)
TCP/IP stands for Transmission Control Protocol/Internet Protocol. The lpd
protocol is the standard TCP/IP printing protocol. The nbt protocol supports
Windows (SMB) printing. The port 9100 is the printer server port number to
publish print connections between the print server and a remote computer. The http
protocol is commonly used for Web pages on the Internet and on intranets. The
http protocol also supports IPP printing.
• IPX/SPX (Novell)
IPX/SPX stands for Internetwork Packet Exchange/Sequenced Packet Exchange.
These protocols are supported on Mac OS, Windows, and UNIX platforms and can
run concurrently on the same cable. Workstations that use other protocols can print
through a server that uses one of the protocols mentioned.
When you add the Fiery to a network, it is assumed that a network administrator has
already installed a network cabling system and connected workstations and servers.
Chapter 1:
Connecting to
the Network