Filter
Top Products
3
3-7 About Setup
5. An administrator and an operator; operator controls all jobs; no WebTool access
(Maximum control)
Only an administrator can perform Setup, calibration, and other administrator
functions, and only an operator or administrator can control jobs from the job
management tools. Users can print only to the Hold queue. The administrator and the
operator have complete control of job flow. There is no access to WebTools.
About Setup
Setup configures the Fiery to communicate with other devices and manage print jobs.
You must perform Setup the first time you turn on the Fiery, or if the internal hard
disk drive has just been replaced. An initial Setup using default settings is adequate for
allowing users to print to the Fiery and use the WebTools. When your network or user
printing environment changes, you can change Setup options accordingly.
The first time you perform Setup, you must use the printer’s Control Panel.
Configure, at a minimum, Server Setup, Network Setup, and Printer Setup, in that
sequence. After the initial Setup, you can change Setup options from the printer’s
Control Panel (page 4-2) or Command WorkStation. Most Setup options can be set
using any of these methods.
If you do not configure the remaining Setups, the Fiery uses default settings. You need
to make settings appropriate for the printing environment at your site.
Use these settings
in Setup
1
(Minimum)
234 5
(Maximum)
Enable Direct connection ✔✔✔
Enable Print queue ✔✔✔✔
Enable Web Services ✔✔✔
Set an Administrator Password
(strongly recommended )
✔✔✔ ✔
Set an Operator password ✔✔ ✔