Filter
Top Products
12
Cisco Connected Grid Modules for CGR 1000 Series—WiMAX Installation and Configuration Guide
OL-26236-03
Installing and Removing the WiMAX Module
Warning
To prevent airflow restriction, allow clearance around the ventilation openings to be at least: 1.75 in.
(4.4 cm)
Statement 1076
Installing the WiMAX Module
The WiMAX module can be installed into any slot of the CGR 1240, however Slot 6 is recommended
due to the ease of installing the available cable.
Note Some WiMAX modules are installed into the host router at the factory.
To install the module into an available slot in the Cisco Connected Grid 1120 Router or the Cisco
Connected Grid 1240 Router:
Note The module can be hot swapped because module online insertion removal (OIR) is allowed—it is not
necessary to power down the router.
Step 1 Before you install (or remove) the Connected Grid WiMAX module from the host router, read the
instructions about installing and removing modules in the Hardware Installation Guide of your router.
Step 2 Insert the WiMAX module in the slot.
Step 3 Using a screwdriver, secure the two captive screws into place.
Removing the WiMAX Module
To remove the WiMAX module from a slot in the Cisco Connected Grid 1120 Router or the Cisco
Connected Grid 1240 Router:
Note The module can be hot swapped because module online insertion removal (OIR) is allowed—it is not
necessary to power down the router.
Step 1 Before you remove the Connected Grid WiMAX module from the host router, read the instructions about
installing and removing modules in the Hardware Installation Guide of your router.
Step 2 Using a screwdriver, loosen the two captive screws on the Connected Grid WiMAX module.
Step 3 Gently pull the WiMAX module out of the slot.