Filter
Top Products
21
Cisco Connected Grid Modules for CGR 1000 Series—WiMAX Installation and Configuration Guide
OL-26236-03
Configuring the Module
Note *—The command, pkm trustpoint device device_cert_trustpoint, is not needed if 1) EAP-TLS is
using the embedded Airspan certificate, or 2) if EAP-TTLS is used.
Enabling an Interface
To configure a WiMAX interface, issue the following commands:
Router# configure terminal
Router(config)# interface wimax 2/1
Router(config-if)# shutdown
Router(config-if)# no shutdown
Router(config-if)# end
Router#
Additional WiMAX Configuration Commands
The following are the WiMAX configuration commands:
• (config)# wimax scan-list scan_list_name
• (config-scan-list)# nap id nap-id priority priority channel-index channel-index
• (config-scan-list)# nsp id nsp-id {home | priority priority channel-index channel-index}
• (config-if)# [no] wimax pkm-version {pkm-v2}
• (config-if)# [no] shutdown
• (config-if)# [no] ip address {IP_address_in_format_i.i.i.i |
IP_prefix_and_network_mask_length_in_format_x.x.x.x/m
IP_network_mask_in_format_m.m.m.m}
WiMAX show Command Examples
The following are WiMAX related show commands:
• show sprom, page 21
• show interfaces wimax interface_name association, page 22
• show controllers wimax interface_name, page 22
• show interfaces wimax interface_name statistics, page 23
• show interface wimax interface_name scanning, page 23
show sprom
To show the command options for the show sprom command, do the following:
Router# show sprom ?
all Show all sproms contents
backplane Show backplane clock module sprom contents
clock Show backplane clock module sprom contents