Filter
Top Products
4-12
Cisco ONS 15454 SDH Procedure Guide, R4.6
January 2004
Chapter 4 Turn Up Node
DLP-D249 Provision IP Settings
Step 5 Click OK. The network view appears. The node icon appears in gray, during which time you cannot
access the node.
Step 6 Double-click the node icon when it becomes green. As necessary, complete the “DLP-D65 Create a
Static Route” task on page 4-15 or the “DLP-D250 Set Up or Change Open Shortest Path First Protocol”
task on page 4-16. If you do not need to create a static route or set up OSPF, continue with the “NTP-D28
Set Up Timing” procedure on page 4-22.
Table 4-1 LED Behavior During TCC2 Reboot
Reboot Activity Active TCC2 LEDs Standby TCC2 LEDs
Standby TCC2 card updated with new
network information.
Memory test (1 to 2 minutes).
If an AIC or AIC-I card is installed,
AIC FAIL and alarm LEDs light up
briefly when the AIC is updated.
The standby TCC2 becomes the active
TCC2.
ACT/STBY: Flashing green. 1. ACT/STBY: Flashing yellow.
2. FAIL LED: Solid red.
3. All LEDs on except ACT/STBY.
4. CRIT turns off.
5. MAJ and MIN turn off.
6. REM, SYNC, and ACO turn off.
7. All LEDs except A&B PWR:
turn off (1-2 minutes)
8. ACT/STBY: Solid yellow.
9. Alarm LEDs: Flash once.
10. ACT/STBY: Solid green.
Memory test (1 to 2 minutes).
TCC2 updated with new network
information.
TCC2 becomes the standby TCC2.
1. All LEDs: Turn off (1 to 2 minutes).
CTC displays “Lost node connection,
switching to network view” message.
2. FAIL LED: Solid red.
3. FAIL LED: Flashing red.
4. All LEDs on except ACT/STBY.
5. CRIT turns off.
6. MAJ and MIN turn off.
7. REM, SYNC, and ACO turn off; all
LEDs are off.
8. ACT/STBY: Solid yellow.
9. ACT/STBY: Flashing yellow.
10. ACT/STBY: Solid yellow.
ACT/STBY: Solid green