Filter
Top Products
4-4
Cisco ONS 15454 SDH Procedure Guide, R4.6
January 2004
Chapter 4 Turn Up Node
NTP-D30 Create Users and Assign Security
NTP-D30 Create Users and Assign Security
Step 1 Complete the “DLP-D60 Log into CTC” task on page 3-24 at the node where you want to create users.
If you are already logged in, continue with Step 2.
Note You must log in as a Superuser to create additional users. The CISCO15 user provided with each
ONS 15454 SDH can be used to set up other ONS 15454 SDH users. You can add up to 500 users
to one ONS 15454 SDH.
Step 2 Complete the “DLP-D74 Create a New User—Single Node” task on page 4-4 or the “DLP-D75 Create
a New User—Multiple Nodes” task on page 4-5 as needed.
Note You must add the same user name and password to each node a user will access.
Step 3 If you want to modify the security policy settings, complete the “NTP-D205 Modify Users and Change
Security” procedure on page 12-25.
Stop. You have completed this procedure.
DLP-D74 Create a New User—Single Node
Step 1 Click the Provisioning > Security > Users tabs.
Step 2 In the Security window, click Create.
Step 3 In the Create User dialog box, enter the following:
• Name—Type the user name. The name must be a minimum of six and a maximum of
20 alphanumeric (a-z, A-Z, 0-9) characters.
Purpose This procedure creates ONS 15454 SDH users and assigns their security
levels.
Tools/Equipment None
Prerequisite Procedures NTP-D24 Verify Card Installation, page 4-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser only
Purpose This task creates a new user for one ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 3-24
Required/As Needed As needed.
Onsite/Remote Onsite or remote
Security Level Superuser only