Filter
Top Products
4-9
Cisco ONS 15454 SDH Procedure Guide, R4.6
January 2004
Chapter 4 Turn Up Node
NTP-D169 Set Up CTC Network Access
NTP-D169 Set Up CTC Network Access
Step 1 Complete the “DLP-D60 Log into CTC” task on page 3-24. If you are already logged in, continue with
Step 2.
Step 2 Complete the “DLP-D249 Provision IP Settings” task on page 4-10 to provision the ONS 15454 SDH IP
address, subnet mask, default router, DHCP, IIOP listener port, and proxy server settings.
Tip If you cannot log into the node, you might be able to change its IP address, default router, and
network mask by using the LCD on the ONS 15454 SDH front panel. See the “DLP-D64 Set the
IP Address, Default Router, and Network Mask Using the LCD” task on page 4-13 for
instructions. However, you cannot use the LCD to provision any other network settings.
Step 3 If static routes are needed, complete the “DLP-D65 Create a Static Route” task on page 4-15. Refer to
the Cisco ONS 15454 SDH Reference Manual for further information about static routes.
Step 4 If the ONS 15454 SDH is connected to a LAN or WAN that uses OSPF, complete the “DLP-D250 Set
Up or Change Open Shortest Path First Protocol” task on page 4-16.
Step 5 If the ONS 15454 SDH is connected to a LAN or WAN that uses RIP, complete the “DLP-D251 Set Up
or Change Routing Information Protocol” task on page 4-18.
Stop. You have completed this procedure.
Purpose This procedure provisions network access for a node, including its subnet
mask, default router, Dynamic Host Configuration Protocol (DHCP)
server, IIOP (Internet Inter-Orb Protocol) listener port, proxy server
settings, static routes, Open Shortest Path First (OSPF) protocol, and
Routing Information Protocol (RIP).
Tools/Equipment None
Prerequisite Procedures NTP-D24 Verify Card Installation, page 4-2
Required/As Needed Required
Onsite/Remote Onsite or remote
Security Level Superuser