Filter
Top Products
4-14
Cisco ONS 15454 SDH Procedure Guide, R4.6
January 2004
Chapter 4 Turn Up Node
DLP-D64 Set the IP Address, Default Router, and Network Mask Using the LCD
Figure 4-2 Changing the IP Address
Step 4 Push the Slot button to move to the IP address or subnet mask digit you need to change. The selected
digit flashes.
Tip The Slot, Status, and Port button positions correspond to the command position on the LCD. For
example, in Figure 4-2, you press the Slot button to invoke the Next command and the Port button to
invoke the Done command.
Step 5 Press the Port button to cycle the IP address or subnet mask to the correct digit.
Step 6 When the change is complete, press the Status button to return to the Node menu.
Step 7 Repeatedly press the Port button until the Save Configuration option appears (Figure 4-3).
Figure 4-3 Selecting the Save Configuration Option
Step 8 Press the Status button to choose the Save Configuration option.
A Save and REBOOT message appears (Figure 4-4).
Figure 4-4 Saving and Rebooting the TCC2
Step 9 Press the Slot button to apply the new IP address configuration, or press Port to cancel the configuration.
Saving the new configuration causes the TCC2 cards to reboot. During the reboot, a “Saving Changes -
TCC Reset” message displays on the LCD. The LCD returns to the normal alternating display after the
TCC2 reboot is complete (see Table 4-1 on page 4-12 for reboot behavior).
Note The IP address and default router must be configured to be on the same subnet. If not, you cannot
apply the configuration.
FAN FAIL
Slot
172.020.214.107
<Next Done Mod>
44090
CRIT MAJ MIN
Status Port
FAN FAIL
Slot
Slot-0
Status=Save Cfg.
44091
CRIT MAJ MIN
Status Port
FAN FAIL
Slot
Save and REBOOT?
<Apply Revert>
44092
CRIT MAJ MIN
Status Port