Filter
Top Products
2-15
Installation Guide for the Cisco MGC Node Manager 2.5(2)
OL-4062-02
Chapter 2 Installing Cisco MGC Node Manager
Performing a New Installation of the Cisco MGC Node Manager
Task 10. Install the CiscoView Security Module
If you are using CiscoView, the CiscoView Security Module must be installed on the CiscoView server
after CiscoView and Cisco MGC Node Manager have been installed.
Step 1 Determine the IP address Cisco MGC Node Manager is using for the CiscoView server. For example, if
Cisco EMF is installed in /opt/cemf, enter:
- /opt/cemf/bin/cmnmupdateCVip -showip
Note An IP address of "0.0.0.0" is the local workstation.
Note If the address is not correct, see “Changing the IP Address of the CiscoView Server If Needed”
section on page 2-13 for how to change it.
Step 2 Locate the CSCOcvsec.pkg that is shipped with the Cisco MGC Node Manager software and resides in
the ciscoviewsecurity directory:
- cd ciscoviewsecurity
If the CiscoView server is not installed on Cisco EMF server, go on to Step 3. If the CiscoView server
is installed on the Cisco EMF server, skip to Step 4.
Step 3 Use ftp to copy the CSCOcvsec package to the CiscoView server using the CiscoView server IP address
you determined with the cmnmupdateCVip command.
- ftp cvserverIPAddress
cd /tmp
binary
put CSCOcvsec.pkg /tmp/CSCOcvsec.pkg
Telnet (or SSH) to the CiscoView server:
- telnet cvserver
You are now ready to install the package.
Step 4 Become the “root” user, (if not already “root”):
- su - root
Step 5 Install the package:
- /usr/sbin/pkgadd -d /tmp/CSCOcvsec.pkg
Note If you uninstall and reinstall Cisco MGC Node Manager, you must reinstall the security package.
Task 11: Set Up the X Terminal Workstations for Remote Access
You can access Cisco MGC Node Manager remotely from a workstation or PC. Cisco MGC Node
Manager has been tested with the Reflection 7.20 X server software package.