Filter
Top Products
Send document comments to nexus3k-docfeedback@cisco.com
2-16
Cisco Nexus 3000 Series Hardware Installation Guide
OL-25338-04
Chapter 2 Installing the Cisco Nexus 3000 Series Switches
Grounding the Switch
To attach the ESD wrist strap to the system ground lug screw for any of the Cisco Nexus 3000 Series
switches, clip the grounding wire to the screw that attaches the grounding lug to the switch chassis (see
Figure 2-7).
Figure 2-7 Attaching the ESD Wrist Strap to the System Ground Lug Screw
In addition, follow these guidelines when handling modules:
• Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
connectors.
• Place a removed component board-side-up on an antistatic surface or in a static-shielding container.
If you plan to return the component to the factory, immediately place it in a static-shielding
container.
• Never attempt to remove the printed circuit board from the metal carrier.
310032
2
1
3
4
5
1 ESD ground strap 4 Clip installed (behind screw)
2 Clip attached to grounding lug 5 System ground connector
3 Side view of grounding lug (clip slid behind
screw)