Cisco Systems N3KC3064TQ32T Switch User Manual


 
Send document comments to nexus3k-docfeedback@cisco.com
3-2
Cisco Nexus 3000 Series Hardware Installation Guide
OL-25338-04
Chapter 3 Connecting to the Network
Preparing for Network Connections
Preparing for Network Connections
When preparing your site for network connections to the Cisco Nexus 3000 Series switch, consider the
following for each type of interface, and gather all the required equipment before connecting the ports:
Cabling required for each interface type
Distance limitations for each signal type
Additional interface equipment required
Connecting to the Console Port
The console port is an RS-232 port with an RJ-45 interface. (See Figure 3-1.) The console port is an
asynchronous (async) serial port; any device connected to this port must be capable of asynchronous
transmission.
We recommend using this port to create a local management connection to set the IP address and other
initial configuration settings before connecting the switch to the network for the first time.
Caution The console port can be used to connect to a modem. If you do not connect it to a modem, connect it
either before powering the switch on or after the switch has completed the boot process.
Figure 3-1 shows how to connect to the console port on the Cisco Nexus 3000 Series switch.
Figure 3-1 Connecting to the Console Port on a Cisco Nexus 3000 Series Switch
You can use the console port to perform the following:
Configure the Cisco Nexus 3000 Series switch from the CLI.
Monitor network statistics and errors.
310031