Filter
Top Products
14-13
User Guide for Cisco Unified Operations Manager
OL-10041-01
Chapter 14 Using Notifications
Configuring Notifications
Step 6 Click Next. The Notification Group Summary page appears, displaying all information entered on the
previous page.
Step 7 Click Finish. The notification information is saved.
Adding and Editing Service Quality Notification Groups
This section describes the procedures for adding or editing a service quality notification group.
Note You can use existing notification groups as templates for creating new notification groups. For
procedures, see Cloning a Notification Group, page 14-17.
Step 1 Select Notifications > Notification Criteria.
Step 2 Do one of the following:
• To add a new group, click Add > Service Quality-Based Criterion.
• To edit an existing group, select the check box next to a service quality notification group and click
Edit.
Depending on your selection, the Add Service Quality-Based Criterion page or Edit Service
Quality-Based Criterion page appears.
Facility list Select a facility from the list (the default is Local Use 0). The Facility field
and the event/alert severity are used for the PRI portion of the syslog
message, as follows:
[Facility*8][Severity]
Event/alert severity values are as follows:
• Critical = 2
• Warning = 4
• Informational = 6
Location field (Optional) Enter location information (up to 29 characters). This
information will be populated in the syslog message.
Hostname editable
column
Enter an IP address or DNS name for the host.
Port editable column Enter a port number on which the syslog daemon is listening. If the port
number is left unspecified (empty), the port defaults to 514.
Note The syslog daemon on the remote system (hostname) must be
configured to listen on a specified port.
Comments editable
column
(Optional) A comment.
GUI Element Description/Action