Filter
Top Products
14-17
User Guide for Cisco Unified Operations Manager
OL-10041-01
Chapter 14 Using Notifications
Configuring Notifications
Step 6 Click Next. The Notification Group Summary page appears, displaying all information entered on the
previous page.
Step 7 Click Finish. The notification information is saved.
Cloning a Notification Group
You can use existing notification groups as templates for creating new notification groups.
Step 1 Select Notifications > Notification Criteria. The Notification Groups page appears.
Step 2 Select the check box next to the notification group that you want to use as the base for your new
notification group.
Step 3 Click Clone. Depending on your selection, the Clone Device-Based Criterion page or the Clone Service
Quality-Based Criterion page appears.
The rest of the procedures for cloning a notification group are the same as when a notification group is
edited. For further instructions, see the following:
• Adding and Editing Device Notification Groups, page 14-10
• Adding and Editing Service Quality Notification Groups, page 14-13
Facility list Select a facility from the list (the default is Local Use 0). The Facility field
and the event/alert severity are used for the PRI portion of the syslog
message, as follows:
[Facility*8][Severity]
Event/alert severity values are as follows:
• Critical = 2
• Warning = 4
• Informational = 6
Location field (Optional) Enter location information (up to 29 characters). This
information will be populated in the syslog message.
Hostname editable
column
Enter an IP address or DNS name for the host.
Port editable column Enter a port number on which the syslog daemon is listening. If the port
number is left unspecified (empty), the port defaults to 514.
Note The syslog daemon on the remote system (hostname) must be
configured to listen on a specified port.
Comments editable
column
(Optional) A comment.
GUI Element Description/Action