Filter
Top Products
7-48
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 7 Controlling Lightweight Access Points
Configuring Failover Priority for Access Points
Step 9 Click Apply to commit your changes.
Step 10 Click Save Configuration to save your changes.
Using the CLI to Configure Failover Priority for Access Points
Using the controller CLI, follow these steps to configure failover priority for access points that join the
controller.
Step 1 To enable or disable access point failover priority, enter this command:
config network ap-priority {enable | disable}
Step 2 To specify the priority of an access point, enter this command:
config ap priority {1 | 2 | 3 | 4} Cisco_AP
where 1 is the lowest priority level and 4 is the highest priority level. The default value is 1.
Step 3 To save your changes, enter this command:
save config
Using the CLI to View Failover Priority Settings
Use these commands to view the failover priority configuration settings on your network:
• To confirm whether access point failover priority is enabled on your network, enter this command:
show network summary
Information similar to the following appears:
RF-Network Name............................. mrf
Web Mode.................................... Enable
Secure Web Mode............................. Enable
Secure Web Mode Cipher-Option High.......... Disable
Secure Shell (ssh).......................... Enable
Telnet...................................... Enable
Ethernet Multicast Mode..................... Disable
Ethernet Broadcast Mode..................... Disable
IGMP snooping............................... Disabled
IGMP timeout................................ 60 seconds
User Idle Timeout........................... 300 seconds
ARP Idle Timeout............................ 300 seconds
Cisco AP Default Master..................... Disable
AP Join Priority......................... Enabled
...