Filter
Top Products
7-78
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 7 Controlling Lightweight Access Points
Viewing Clients
This page shows the following information:
• The general properties of the client
• The security settings of the client
• The QoS properties of the client
• Client statistics
• The properties of the access point to which the client is associated
Using the CLI to View Clients
Use these CLI commands to view client information.
• To see the clients associated to a specific access point, enter this command:
show client ap {802.11a | 802.11b} Cisco_AP
Information similar to the following appears:
MAC Address AP Id Status WLAN Id Authenticated
----------------- ------ ------------- --------- -------------
00:13:ce:cc:8e:b8 1 Associated 1 No
• To see a summary of the clients associated to the controller’s access points, enter this command:
show client summary
Information similar to the following appears:
Number of Clients................................ 6
MAC Address AP Name Status WLAN Auth Protocol Port Wired
----------------- ----------------- ------------- ---- ---- -------- ---- -----
00:13:ce:cc:8e:b8 Maria-1242 Probing N/A No 802.11a 1 No
00:40:96:a9:a0:a9 CJ-AP1 Probing N/A No 802.11a 1 No
00:40:96:ac:44:13 CJ-AP1 Probing N/A No 802.11a 1 No
00:40:96:b1:fe:06 CJ-AP1 Probing N/A No 802.11a 1 No
00:40:96:b1:fe:09 CJ-AP1 Probing N/A No 802.11a 1 No
• To see detailed information for a specific client, enter this command:
show client detail client_mac
Information similar to the following appears:
Client MAC Address............................... 00:40:96:b2:a3:44
Client Username ................................. N/A
AP MAC Address................................... 00:18:74:c7:c0:90
Client State..................................... Associated
Wireless LAN Id.................................. 1
BSSID............................................ 00:18:74:c7:c0:9f
Channel.......................................... 56
IP Address....................................... 192.168.10.28
Association Id................................... 1
Authentication Algorithm......................... Open System
Reason Code...................................... 0
Status Code...................................... 0
Session Timeout.................................. 0
Client CCX version............................... 5
Client E2E version............................... No E2E support