Filter
Top Products
B-63
Cisco Media Gateway Manager 5.0 User Guide
OL-5461-02
Appendix B Error Messages
Cisco MGM Server Error Messages
Error Message EID-1025: Could not get access to one of the circuit nodes. Verify that
you have user privileges for all of the nodes in this circuit. Contact the
administrator if the problem persists.
Recommended Action
Verify that you have user privileges for all the nodes in the circuit. If the
problem persists, contact your system administrator.
Error Message EID-1026: This circuit has been deleted from another interface. This
window will close.
Recommended Action
No action.
Error Message EID-1026: Roll creation request failed.
Recommended Action
Try again. Contact system administrator for more information.
Error Message EID-1027: Error: Cannot proceed with roll creation.
Recommended Action
Close the wizard and try again.
Error Message EID-1028: Error occurred while setting the roll-to-point. Try again.
Recommended Action
Perform the operation again.
Error Message EID-1029: Roll-to-point is not fully specified. Choose available
points.
Recommended Action
Choose available points.
Error Message EID-1030: Select the circuit termination point.
Recommended Action
Select the circuit termination point.
Error Message EID-1031: The selected roll path is invalid.
Recommended Action
Choose a valid circuit termination point as the roll path.
Error Message EID-1032: Failed to complete the roll.
Recommended Action
Contact your system administrator.
Error Message EID-1033: Failed to delete the roll.
Recommended Action
Contact your system administrator.