Filter
Top Products
4-10
Cisco IP Solution Center Integrated VPN Management Suite Security User Guide, 3.2
OL-5532-02
Chapter 4 Remote Access VPN Services
Creating Remote Access VPN Policies
Note You can click Finish on any of the Remote Access VPN Policy pages. When you click Finish, the
unedited policy parameters take the default settings provided by ISC, and ISC saves the policy to your
repository.
Defining Address Pools
In this section, you create the IP address pools that remote clients use to establish IPsec tunnels to the
private site. Remote clients are assigned an inside IP address from these pools.
Step 1 From the Remote Access VPN Policy – General Editor page click Address Pools. The Remote Access
VPN Policy – Address Pools page appears as shown in Figure 4-8.
Note From the ISC home page, you can navigate to this page by clicking Service Design > Policies > Create
> IPsec Policy > Remote Access VPN Policy, entering values in the Remote Access VPN Policy –
General Editor, and then clicking Next.
Figure 4-8 The Remote Access VPN Policy – Address Pools Page
Step 2
Click Create to add the remote access IP address pool. The Address Pools dialog box appears as shown
in Figure 4-9.