Filter
Top Products
4-12
Cisco IP Solution Center Integrated VPN Management Suite Security User Guide, 3.2
OL-5532-02
Chapter 4 Remote Access VPN Services
Creating Remote Access VPN Policies
Step 6 Click Next to continue to the Split Tunneling Network page as shown in Figure 4-11 in the “Defining
Split Tunneling Networks (Optional)” section on page 4-12.
Defining Split Tunneling Networks (Optional)
You can enable or disable split tunneling for remote users. To set the split tunneling parameters, perform
the following steps:
Step 1 The Remote Access VPN Policy – Split Tunneling Network List page appears as shown in Figure 4-11.
Note From the ISC home page, you can navigate to the Split Tunneling Network page by clicking Service
Design > Policies > Create > IPsec Policy > Remote Access VPN Policy, entering values for the
General Editor and Address Pools pages, and then clicking Split Tunneling.
Figure 4-11 Remote Access VPN Policy – Split Tunneling Network List Page
Step 2 Follow the instructions in Table 4-4 to choose your split tunneling options. For example, click Create to
add IP addresses to the split tunneling network list.
Note Once the list is populated using Create, Generate, or both options, you can edit the list until it contains
the desired networks from which traffic must travel through the IPsec tunnel.