Cisco Systems OL-6217-01 Network Router User Manual


 
Cisco Structured Wireless-Aware Network (SWAN) Implementation Guide
Implementing the Cisco SWAN Framework
30
Cisco Structured Wireless-Aware Network (SWAN) Implementation Guide
OL-6217-01
You should also navigate to the Catalyst 6500 Supervisor command-line interface and validate that the
control communications between the WLSM and supervisor are correctly working. Enter this command
to take a general look at the status:
show mobility status
Enter this command to show the slot location of the WLSM, the LCP status, tunnel information,
registered access points, registered mobile nodes, and important information about the tunnels:
sup720# show mobility status
WLAN Module is located in Slot: 1 (HSRP State: Not Applicable)
LCP Communication status: up
MAC address used for Proxy ARP: 0008.2034.7400
Number of Wireless Tunnels: 4
Number of Access Points: 1
Number of Mobile Nodes: 3
Wireless Tunnel Bindings:
Src IP Address Wireless Network-ID Trusted Broadcast
--------------- ------------------- ------- ---------
10.100.1.1 1 No Yes
10.100.2.1 2 Yes Yes
10.100.3.1 3 Yes Yes
10.100.4.1 4 Yes No
Enter the following command to show information about the registered access points:
show mobility ap
The IP addresses, MAC addresses, and appropriate network identifiers for the registered access points
are shown:
sup720# show mobility ap
AP IP Address AP Mac Address Wireless Network-ID
--------------- -------------- -------------------
10.200.20.49 000b.fcfb.e836 4
Enter the following command to show information about registered client mobile nodes:
show mobility mn
The MN MAC address, MN IP address, the IP address of the MN's current access point, and the network
identifier of the MN is shown:
sup720# show mobility mn
MN Mac Address MN IP Address AP IP Address Wireless Network-ID
-------------- --------------- --------------- -------------------
0004.e28b.2c28 172.16.4.3 10.200.20.49 4
00d0.59c8.60e1 172.16.4.2 10.200.20.49 4
Enter the following command to show information about a specific mobility group.
show mobility network <network-id>