Filter
Top Products
1-9
Cisco AC/DC Power System User Guide, R1.0
May 2006
Chapter 1 Introduction
1.2.1 Installation Warning
Figure 1-8 ESD Wrist Strap Connection Point
•
Keep the system area clear and dust-free during and after the installation.
• Always check for possible hazards before beginning work.
• This equipment is designed to permit the connection of a grounded conductor for the DC supply
circuit at the equipment.
1.2.1 Installation Warning
The following safety guidelines should be observed when transporting or moving the system to the
install location:
• Before moving the Cisco AC/DC Power System, read the system specifications sheet to determine
if the site meets all the size, environmental, and power requirements.
• The Cisco AC/DC Power System should be properly mounted to the equipment rack.
The Cisco AC/DC Power System is designed for installation in restricted access locations. A restricted
access location is defined as an equipment location where both of the following conditions apply:
• Access can only be gained by service persons or users who understand the restrictions applied to the
location and any precautions that must be taken.
• Access to the system is obtained through the use of a tool or lock and key, or other means of security,
and is controlled by the authority responsible for the location.
1.2.2 Operating Temperature Warnings
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of: 55° Celsius.
Statement 1047
124769
ESD Connection
Point