Cisco Systems 124792 Power Supply User Manual


 
CHAPTER
2-1
Cisco AC/DC Power System User Guide, R1.0
May 2006
2
System Installation
This provides step-by-step instructions for installing a Cisco AC/DC Power System. If you are installing
a new system, begin with the “2.1 Pre-Installation” section on page 2-1. If you are upgrading an existing
system, go to the “2.6 System Upgrades” section on page 2-28 for instructions.
2.1 Pre-Installation
The following information should be reviewed before attempting to install the Cisco AC/DC Power
System.This section includes shelf markings, tools, equipment, and an installation checklist. Refer to the
“1.2 Safety Recommendations” section on page 1-8 before beginning installation.
Note Each system installation is unique, so please review specific site requirements and system configurations
before installing the system.
2.1.1 Ground Symbol
Figure 2-1 shows the ground symbol located on the Cisco AC/DC Power System.
Figure 2-1 Ground Symbol
2.1.2 Tools Required
The following tools and parts are required for safe installation of the Cisco AC/DC Power System:
Digital multimeter
124774