Filter
Top Products
Chapter 4
Bi-Admin Management
9
PrintServer for USB with 4-Port Switch
Chapter 4:
Bi-Admin Management
Overview
The PrintServer is managed by a utility program called
Bi-Admin on the PrintServer’s Setup CD. Fully compatible
with Windows 98, Me, 2000, and XP, Bi-Admin allows you
to change the PrintServer’s internal settings, check the
unit’s status, and perform basic diagnostic tests.
Note that the Bi-Admin program must be installed only
on the network administrator’s computer. First, you will
install Bi-Admin on your computer. Then, you will be able
to use the management utility.
Bi-Admin Installation
If you have not already done so, insert the Setup CD-1.
ROM into the PC’s CD-ROM drive. The Setup CD-ROM
should run automatically. If it does not, click Start
and choose Run. In the box that appears, enter D:\
setupWizard.exe (if “D” is the letter of your CD-ROM
drive).
When you see the 2. Welcome screen, click Bi-Admin
Install to continue. Click Exit to end the installation.
Welcome
The Bi-Admin program’s 3. Welcome screen will appear.
If any other programs are open at this time, close
them before continuing; click Cancel to quit the setup
program, then close the open programs. Otherwise,
click Next to continue with the Bi-Admin installation.
Bi-Admin Welcome
The 4. Choose Destination Location screen lists the default
location where the Bi-Admin folder will be installed. If
you want to install the folder in a different location, click
Browse and select the location. To install the folder in
the default location, click Next to continue. Click Back
to return to the previous screen. Click Cancel to end
the Bi-Admin installation.
Choose Destination Location
The 5. Select Program Folder screen appears. An icon
will be added to the program folder listed. If desired,
change the name for the program folder. Click Next.
Click Back to return to the previous screen. Click
Cancel to end the Bi-Admin installation.
Select Program Folder