Filter
Top Products
60
Route Switch Processor (RSP8) Installation and Configuration Guide
OL-4920-02
Enabling High Availability Features
Performing a Fast Software Upgrade
To perform a Fast Software Upgrade (FSU), use the following commands beginning in privileged EXEC
configuration mode:
Command Purpose
Step 1
Router# copy tftp slotslot-number:
Address or name of remote host []?
ip-address
Name of file to copy []?
imagename
<Return>
writing filename!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Destination filename? [
imagename1
] <Return>
Accessing tftp://
host ip-address
/file 'imagename' on
ip-address.. found !
11188128 bytes copied in 2280.664 secs (4906
bytes/sec)
Uses TFTP to copy a high availability Cisco IOS
image onto the Flash memory card or Flash Disk of
the active RSP.
1
• slotslot-number—Specifies the Flash memory
card or Flash Disk of the active RSP.
The router prompts you for the IP address of the
TFTP server.
• ip-address—Specifies the IP address of the
TFTP server that contains the new image.
The router prompts youfor the name of the imagefile
you are copying to the Flash memory card or Flash
Disk.
• imagename—Indicates the name of the image to
be loaded onto the Flash memory card or Flash
Disk.
The router promptsyou to typethe name under which
you want the file to appear at the destination.
• imagename1—Indicates the name of the image
as it appears at the destination.
Note Step 1 and Step 2 arethe same.Step 1 applies
to the active RSP, and Step 2 applies to the
the standby RSP.