Filter
Top Products
38
• All cards must have an oper-status of “Up”
a. Click on the newly copied.img file in the File Management window.
b. Click the Install button.
c. Click Ye s to the warning asking if you wish to proceed.
NOTE: If you do not have enough available memory to install an additional image, delete an old
image. “Delete an Image with the GUI” on page 39.
6. Specify the new boot image to be used.
a. Select Maintenance-> Boot Config….The Boot Configuration window appears.
Figure 3-16: Specify the Boot Configuration
b. Select the new boot image from the Image Source for Next Reboot drop-down menu.
c. Click the Apply button.
7. Reboot the chassis. Note: you can update the software on an individual gateway by enabling and
disabling the gateway.
a. Select Maintenance-> Boot Config….
b. Click yes to in the Save changes to the system configuration dialog box.
c. Click Ok in the The chassis will now be rebooted dialog box.
Delete an Image with the CLI
You can delete an .img file through the CLI or the GUI. A .img file is an image file that is not installed.
Do not delete an installed image file. An installed image will have a slash (/) in the name.
1. Delete an image (.img file) from the switch using the delete command with the following syntax:
delete [slot-number:]file-system:file