Filter
Top Products
Configuring Secure Domain Routers on Cisco IOS XR Software
How to Configure Secure Domain Routers
SMC-141
Cisco IOS XR System Management Configuration Guide
Complete the following steps to create a non-owner SDR.
Note The procedures in this section can be performed only on a router that is already running the
Cisco IOS XR software. For instructions to boot a router and perform the initial configuration, see the
Cisco IOS XR Getting Started Guide. When a router is booted, the owner SDR is automatically created,
and cannot be removed. This also includes instructions to create owner SDR username and password.
SUMMARY STEPS
1. admin
2. configure
3. (Optional) pairing pair-name
4. (Optional) location partially-qualified-nodeid partially-qualified-nodeid
5. (Optional) exit
6. sdr sdr-name
7. pair pair-name primary
or
location partially-qualified-nodeid primary
8. location partially-qualified-nodeid
or
pair pair-name
9. Repeat Step 8 as needed to add nodes to an SDR.
10. exit
11. Repeat Step 3 through Step 10 as needed to create additional secure domain routers.
12. end
or
commit
13. Create a username and password for the new SDR as described in the “Configuring a Username and
Password for a Non-Owner SDR” section on page SMC-157.