Filter
Top Products
2-18
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-03
Chapter2 Configuring the Cable Modem Termination System for the First Time
Configuring the Cisco uBR7200 Series Using the Setup Facility
When the router determines that AutoInstall is not configured, it defaults to the Setup facility. If the LAN or
WAN cable is not connected, the router boots from Flash memory and automatically runs the Setup facility.
Note You can run the Setup facility when the enable prompt (#) is displayed, by entering the setup command
in privileged EXEC mode.
Configuring Global Parameters with the Setup Facility
When you first start the program, configure the global parameters to control system-wide settings:
Step1 Connect a console terminal to the console port on the I/O controller, and then boot the router.
Step2 After booting from Flash memory, the following information appears after about 30seconds. When you
see this information, you have successfully booted your router:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (UBR7200-IK1S-M), Version 12.1(10)EC
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Fri 24-Nov-01 12:59 by yiyan
Image text-base: 0x60008950, data-base: 0x61478000
Compliance with U.S. Export Laws and Regulations - Encryption
This product performs encryption and is regulated for export
by the U.S. Government.
This product is not authorized for use by persons located
outside the United States and Canada that do not have prior
approval from Cisco Systems, Inc. or the U.S. Government.
This product may not be exported outside the U.S. and Canada
either by physical or electronic means without PRIOR approval
of Cisco Systems, Inc. or the U.S. Government.
Persons outside the U.S. and Canada may not re-export, resell,
or transfer this product by either physical or electronic means
without prior approval of Cisco Systems, Inc. or the U.S.
Government.
Cisco uBR7246VXR (NPE300) processor (revision D) with 253952K/40960K bytes
of memory.
Processor board ID SAB0433019F
R7000 CPU at 262Mhz, Implementation 39, Rev 2.1, 256KB L2, 2048KB L3 Cache
6 slot VXR midplane, Version 2.0