Filter
Top Products
Supported MIBs and RFCs
8
Cisco IOS Release 12.0(5)T
• The CMTS system administrator must ensure appropriate databases are updated to activate and
support the new subscriber account in the provisioning, billing and/or network management
systems in place for your network once each router is registered with the CMTS.
• The PC(s) connected to the Cisco uBR924 cable access router must be configured for IP.
• Cisco IOS Release 11.3(4)NA or later must be running on the Cisco uBR924 cable access router.
When the cable access router is up and running, you can display the IOS release number by
entering the show version command from user EXEC mode.
Note If the Cisco uBR7246 universal broadband router at the cable headend is using MC16 modem
cards, Cisco IOS Release 11.3(7)NA or later must be running on the Cisco uBR924 cable access
router.
In order to use the Cisco uBR924 cable access router for VoIP-over-cable applications, the following
additional conditions must be met:
• In order to run VoIP Fax, the uBR924 cable access router must be configured for voice and you
must be using Cisco IOS Release 12.0(5)T or higher.
Supported MIBs and RFCs
The Cisco uBR924 cable access router supports the following:
• Cisco Standard MIBs:
— Cisco Product MIB
— Cisco Chassis MIB
— Cisco Syslog MIB
— Cisco Flash MIB
— Bridge MIB
— IF MIB
— MIB-II
• Cisco VoIP MIBs:
— Cisco Voice IF MIB
— Cisco Voice Dial-Control MIB
— Cisco Voice Analog IF MIB
— Cisco Dial-Control MIB
• Radio Frequency Interface Specification—Developed by the Multimedia Cable Network System
(MCNS) consortium. It defines the radio-frequency interface specification for high-speed
data-over-cable systems.
• CiscoWorks—Network management program for planning, troubleshooting, and monitoring
Cisco internetworks. CiscoWorks uses Simple Network Management Protocol (SNMP) to
monitor all SNMP devices.
— For more information about CiscoWorks on CCO, follow this path:
Products & Ordering: Cisco Products: Network Management: CiscoWorks