Filter
Top Products
Comments to ucs-docfeedback@cisco.com
14
Cisco UCS B230 Blade Server Installation and Service Note
OL-23811-01
Removing and Installing a UCS B230
Installing a Cisco UCS B230 Blade Server
To install a blade server, follow these steps:
Step 1 Grasp the front of the blade server and place your other hand under the blade to support it.
Step 2 Open the ejector lever in the front of the blade server. (See Figure 4.)
Figure 4 Inserting a Blade Server in the Chassis
Step 3
Gently slide the server into the opening until you cannot push it any farther. At a certain point it will
engage the ejector lever.
Step 4 Press the ejector lever as it catches the edge of the chassis and presses the blade server all the way in.
Give a gentle push to the rear to be sure the server is fully seated into the midplane.
Step 5 Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening with bare fingers
only is unlikely to lead to stripped or damaged captive screws.
199988