Filter
Top Products
Simple Network Management Protocol
Ta rg e t s
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE 141
8
• Group—The group that the user is mapped to. The default groups are
RWAuth, RWPriv, and RO. You can define additional groups on the SNMP
Groups page.
• Authentication Type—The type of authentication to use on SNMPv3
requests from the user, which can be one of these options:
- MD5—Require MD5 authentication on SNMP requests from the user.
- None—SNMPv3 requests from this user require no authentication.
• Authentication Pass Phrase—(If you specify MD5 as the Authentication
Type) A pass phrase to enable the SNMP agent to authenticate requests
sent by the user. The pass phrase must be between 8 and 32 characters in
length.
• Encryption Type—The type of privacy to use on SNMP requests from the
user, which can be one of these options:
- DES—Use DES encryption on SNMPv3 requests from the user.
- None—SNMPv3 requests from this user require no privacy.
• Encryption Pass Phrase—(If you specify DES as the privacy type) A pass
phrase to use to encrypt the SNMP requests. The pass phrase must be
between 8 and 32 characters in length.
STEP 5 Click Save. The user is added to the SNMPv3 Users list and your changes are
saved to the Startup Configuration.
NOTE To remove a user, select the user in the list and click Delete.
Tar ge t s
SNMPv3 targets send SNMP notifications using Inform messages to the SNMP
Manager. For SNMPv3 targets, only Informs are sent, not traps. For SNMP versions
1 and 2, traps are sent. Each target is defined with a target IP address, UDP port,
and SNMPv3 user name.
NOTE SNMPv3 user configuration (see the Users page) should be completed before
configuring SNMPv3 targets.
NOTE The WAP device supports a maximum of eight targets.