Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WAN Interface Card
How to Configure the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC
12
Cisco IOS Release 12.3(14)T
DETAILED STEPS
Examples
This example shows the output of the upgrade modem firmware all command with a 1-port
Cisco WIC-1AM-V2 modem in 0/1 (slot/wic-slot) and a 2-port Cisco WIC-2AM-V2 modem in 1/0
(slot/wic-slot).
Example:
Loading mj-F48A-1824M-4M-Rev-2-bundle-image.bin from
192.188.100.26 (via FastEthernet0/0):
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 282816 bytes]
Verifying the modem firmware bundle - Passed
Decompressing modem firmware image - Done
TTY1: Upgrading modem firmware
TTY33: Upgrading modem firmware
TTY34: Upgrading modem firmware
Downloading modem firmware. Please Wait
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
upgrade modem firmware [all | slot slot | wic
nm-slot/wic-slot] file source
Example:
Router# upgrade modem firmware all
Enters information needed for the modem firmware
upgrade:
• all—Select all the modems in the router that are
supported by the modem firmware file.
• slot—Specify the router slot that is supported by the
modem firmware file.
• slot—Number of the slot selected.
• wic—Specify a WIC supported by the modem firmware
file.
• nm-slot—Number of the slot where the network
module is located.
• wic-slot—Number of the slot where the WIC is located.
• file—Obtains the firmware information from the file
named as source.
• source—Name of the file with the firmware upgrade.
Step 3
exit
Example:
Router# exit
Exits privileged EXEC mode.