Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WAN Interface Card
How to Configure the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC
14
Cisco IOS Release 12.3(14)T
The show modem [slot/port | group number] command shows various performance statistics for a
modem or group of modems.
Example:
Router# show modem 0/3/0
Mdm Typ Status Tx/Rx G Duration TX RX RTS CTS DSR DCD DTR
0/3/0 UnKn Idle / 0 00:00:00 - - x x x x
Modem 0/3/0 [line 50], Async0/3/0, TTY50
WIC-AM firmware ACF3_V1.922F-V90_4M_FSH
Modem config: Incoming and Outgoing
Protocol: UnKn, Compression: UnKn
Last clearing of "show modem" counters: never
0 incoming complete
0 incoming failures
0 outgoing complete
0 outgoing failure
Troubleshooting the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC
To troubleshoot the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC, use the following
commands, starting in privilege EXEC configuration mode.
• Debugging Call Connect, page 14
• Debugging Call Disconnect, page 16
Debugging Call Connect
Complete the following steps to debug call connect on the Cisco WIC-1AM-V2 and WIC-2AM-V2
Analog Modem WIC.
SUMMARY STEPS
1. enable
2. debug modem
3. debug dialer
4. ping system-address
5. exit