Filter
Top Products
Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WAN Interface Card
How to Configure the Cisco WIC-1AM-V2 and WIC-2AM-V2 Analog Modem WIC
15
Cisco IOS Release 12.3(14)T
DETAILED STEPS
Examples
This command shows the state of the TTY lines.
Example:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.2, timeout is 2 seconds:
Feb 10 20:33:53: Modem Registers - IMR:0x0 LED:0x0 RstCntrl:0x0 MSR:0xFF
Feb 10 20:33:53: As1 DDR: place call
Feb 10 20:33:53: As1 DDR: Dialing cause ip (s=10.0.0.1, d=10.0.0.2)
Feb 10 20:33:53: As1 DDR: Attempting to dial 2-2772
Feb 10 20:33:53: CHAT1: Attempting async line dialer script
Feb 10 20:33:53: Modem Registers - IMR:0x0 LED:0x0 RstCntrl:0x0 MSR:0xFF
Feb 10 20:33:53: CHAT1: Dialing using Modem script: dial & System script: none
Feb 10 20:33:53: CHAT1: process started
Feb 10 20:33:53: CHAT1: Asserting DTR
Feb 10 20:33:53: CHAT1: Chat script dial started.....
Success rate is 0 percent (0/5)
Feb 10 20:34:18: Modem (0/0) DCD Asserted
Feb 10 20:34:18: Modem 0/0 WIC-AM: in modem state 'Connect'
dte = 115200 modulation= V34 protocol = LAPM compression_type = V42B tx_speed = 33600
rx_speed = 33600
Feb 10 20:34:18: CHAT1: Chat script dial finished, status = Success
Feb 10 20:34:18: Modem 0/0 WIC-AM: switching to PPP mode
Feb 10 20:34:18: TTY1: no timer type 1 to destroy
Feb 10 20:34:18: TTY1: no timer type 0 to destroy
Feb 10 20:34:18: TTY1: no timer type 2 to destroy
Feb 10 20:34:20: %LINK-3-UPDOWN: Interface Async1, changed state to up
Command or Action Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
• Enter your password if prompted.
Step 2
debug modem
Example:
Router# debug modem
Aids in troubleshooting the modem WIC.
• Use the no form of the command to stop the debugging
process.
Step 3
debug dialer
Example:
Router# debug dialer
Aids in troubleshooting the modem WIC.
• Use the no form of the command to stop the debugging
process.
Step 4
ping system-address
Example:
Router# ping 10.0.0.2
Diagnose basic network connectivity with the modem WIC.
• system-address—Address of the system to ping. If a
host-name or system-address is not specified, it will be
required in the ping system dialog.
Step 5
exit
Example:
Router# exit
Exits privileged EXEC mode.