Filter
Top Products
CBM-920 User’s Manual
19 CITIZEN
4.7 Self-Printing Function
(1) Test Printing By supplying power as pushing the LF switch, the characters for use, ROM version, DIP
switch setting, and model name can be printed.
After test printing, perform ordinary operation.
By sending RESET signals as pushing the LF switch, perform test printing.
During self printing, BUSY signal is being outputted.
In this test printing, the following information is printed.
1 ) Specified country for international character
2) CR + LF function
3) Direction of print character
4) Communication condition (Serial interface only)
(2) Hex decimal dump mode
In this mode, all of the data sent from the host is printed at Hex decimal code. In case that the data of
last line is not enough for one line, the data of last line is printed by pressing LF switch.
This mode can be available by turning ON the Dip Switch DS1-8.
After Power is ON (after printing, if self print is conducted), this mode is available.
This mode can be kept until Power is OFF.
To change to normal print mode, turn Power OFF after turning Dip switch DS1-8 OFF, and then turn
Power ON.
This function is only available for 40 columns model.
This function is not available for 24 columns model.
Example of printing at dump mode. (40 columns model)