Filter
Top Products
CBM-920 User’s Manual
41 CITIZEN
(10) Defining the download character command (ESC + "&")
1 In case of 24 columns mode
By inputting ESC (1BH) + "&" (26H) + A1 + A2 code and the pattern data following after this code,
nominated pattern can be registered.
Maximum numbers of characters can be registered are 8 characters and this can be registered into the
nominated address range between 20H and FFH.
Make sure that in case new data is registered to th e address range already has old data, the old data is
automatically overwritten and new data is registered.
Furthermore, in case the data over 8 characters is registered, all of the previous data is cleared
automatically.
[Specifying address]
The specified address conforms to the character codes and these characters can be accessed as well as the
internal characters after registration.
In case any internal characters already exists in the address specified for registered characters, the internal
characters are replaced.
A1 means the address of start to be registered and A2 means the address of finish to be registered.
[Data transmission method]
d-1) In case of one character registration The address is to be specified from the 20H ~ FFH, then the
specified address is considered as A1. In case of one character registration, the address of start and
finish are to be same. Therefore, A1 = A2.
<Example> One full dot pattern of 6 × 8 dots matrix is registered to address 41H. (The code of internal
character "A".) (Number is Hex. Mode.)
ESC + "&" + A1 + A2 + "Pattern data (6 bytes)"
IB 26 41 41 FF•FF•FF•FF•FF•FF
After the above control, in case the character code of 41H is specified, full dot printing of 6 × 8 dot matrix
printing is performed. (Character "A" can not be accessed to.)