Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5-20 Removal and Replacement Procedures
5.4 External Computer Components
This section describes the removal and replacement procedures that do not require
access to the internal components of the computer. This includes:
Computer logo
Computer feet
Computer handle
5.4.1 Computer Logo
The computer logo is on the outside of the display assembly and may be replaced if
damaged. To replace the logo, complete the following steps:
1. Use a small sharp flat-bladed screwdriver to pry up the existing logo.
2. Clean the area with a clean dry cloth.
3. Install the new logo in the area shown in the figure.
Figure 5-18.
Attaching the Computer Logo