Filter
Top Products
2-4 Compaq StorageWorks 64-Bit/66-MHz Fibre Channel Host Adapter
Compaq Confidential – Need to Know Required
Writer: Liz M. Weiman Project: Guide Title Comments:
Part Number: 122833-002 File Name: c-ch2 Installing.doc Last Saved On: 1/4/01 12:54 PM
Running System ROMPaq
System ROMPaq is used to update the firmware in Compaq servers. The new
storage systems have enhanced drive array capabilities and many existing
servers require updated firmware to take advantage of these capabilities. Since
it is difficult to determine when the firmware was last updated, Compaq
recommends running the latest System ROMPaq on your server before
installing a new 64-Bit/66-MHz Fibre Channel Host Adapter.
To run System ROMPaq:
1. Place the System ROMPaq diskette in the server diskette drive.
2. Start the server by turning on the power.
3. Press Enter at the Welcome screen.
4. At the Select A Device screen, select the server from the list of
programmable devices. There may only be one item in the list.
Press Enter.
5. At the Select An Image screen, you will see:
Device to reprogram: your server
Current ROM revision: date of existing ROM version
Select Firmware Images: date of latest ROM version
Press Enter.
6. Review the information on the Caution screen:
Device to reprogram: your server
Current ROM revision: date of existing ROM version
Selected ROM revision: date of ROM version to be installed
Press Enter to reprogram the system ROM or Esc (escape) to
discontinue reprogramming and return to the Select An Image screen.
Do not interrupt when “Reprogramming Firmware” appears on the
screen. The system ROM is being reprogrammed.
IMPORTANT: Do not interrupt the reprogramming. Interrupting the ROM reprogramming
will leave the firmware in an unknown state. You may not be able to boot the server if this
happens. You will be notified when reprogramming is completed.