Filter
Top Products
3-2 MHz Fibre Channel Host Adapter Installation Guide
Compaq Confidential – Need to Know Required
Writer: Liz M. Weiman Project: MHz Fibre Channel Host Adapter Installation Guide Comments:
Part Number: 122833-002 File Name: d-ch3 Installing Drivers for Novell NetWare.doc Last Saved On: 12/14/00 2:18 PM
Installing the Drivers
Follow the instructions in this chapter to install the drivers manually for a new
installation or to upgrade the drivers in an existing NetWare server.
Driver Installation from the RA4100 SAN Solution
Support Software CD
The latest Novell NetWare drivers and support files for the 64-Bit/66-MHz
Fibre Channel Host Adapter are located on the RA4100 SAN Solution Support
Software CD. To install the drivers from the RA4100 SAN Solution Support
Software CD, follow the instructions found inside the RA4100 SAN Solution
Support Software CD-ROM sleeve.
IMPORTANT: Before installing or upgrading support for your Compaq 64-Bit/66-MHz
Fibre Channel Host Adapter, make sure you have installed the latest Novell Support Pack
for the version of the NetWare operating system in use. Novell Support Packs can be
obtained at support.novell.com
NOTE: Compaq SmartStart and Support Software CD with a higher revision number than
the RA4100 SAN Solution Support Software may contain an updated version of RA4100
SAN Solution software.
Driver Installation from the Compaq SmartStart
and Support Software CD
1. From the NetWare 4.2 console, type:
Load Install
or
From the NetWare 5.1 console, type:
Load Nwconfig
2. Select Product Options from the menu and press Enter.
3. Select Install a product not listed and press Enter.
4. Press F3 to specify a different path.
5. Insert the Compaq SmartStart and Support Software CD into the
server’s CD-ROM drive.
6. Do one of the following: