Filter
Top Products
Government Approvals 2-11
New Zealand Modem Statements
The grant of a Telepermit for any item of terminal equipment indicates only that
Telecom has accepted that the item complies with minimum conditions for
connection to its network. It indicates no endorsement of the product by Telecom, nor
does it provide any sort of warranty. Above all, it provides no assurance that any item
will work correctly in all respects with another item of Telepermitted equipment of a
different make or model, nor does it imply that any product is compatible with all of
Telecom’s network services.
This equipment is not capable, under all operating conditions, of correct operation at
the higher speeds for which it is designed. Telecom will accept no responsibility
should difficulties arise in such circumstances.
This device is equipped with pulse dialing while the Telecom standard is DTMF tone
dialing. There is no guarantee that Telecom lines will always continue to support
pulse dialing.
Use of pulse dialing, when this equipment is connected to the same line as other
equipment, may give rise to bell tinkle or noise and may also cause a false answer
condition. Should such problems occur, the user should not
contact the Telecom
Faults Service.
Some parameters required for compliance with Telecom’s Telepermit requirements
are dependent on the equipment (PC) associated with this device. The associated
equipment shall be set to operate within the following limits for compliance with
Telecom’s Specifications:
1. There shall be no more than 10 call attempts to the same number within any 30
minute period for any single manual call initiation, and
2. The equipment shall go on-hook for a period of not less than 30 seconds between
the end of one attempt and the beginning of the next attempt.
Where automatic calls are made to different numbers, the equipment shall go on-
hook for a period of not less than 5 seconds between the end of one attempt and the
beginning of the attempt.
The equipment shall be set to ensure that calls are answered between 3 and 30
seconds of receipt of ringing (S0 set between 2 and 10). This ensures the following:
1. A person calling your modem will hear a short burst of ringing before the
modem answers. This confirms that the call has been successfully switched
through the network.