Filter
Top Products
Conceptronic C300BRS4 User Manual
43
L2TP Parameters Description
IP Address The IP address that will be assigned to your router for this connection,
as stated by your ISP.
Subnet Mask The IP address of the corresponding Subnet Mask, as stated to you by
your ISP.
ISP Gateway Address The IP address of the gateway device, as stated to you by your ISP.
DNS Enter the Domain Name Server IP address.
Server IP The IP address of your ISP’s server computer, as stated to you by your
ISP.
User Name The account name of the L2PT account that has been assigned to you
by your ISP.
Password The password of the L2PT account that was supplied to you by your
ISP.
Retype Password Retype the password that was entered in the L2PT field. Ensure that
these two passwords are identical or an error will occur.
Maximum Idle Time A value of 0 means that the PPP connection will remain connected. If
your network account is billed according to the amount of time the
Router is actually connected to the Internet, enter an appropriate Idle
Time value (in minutes). This will disconnect the Router after the
WAN connection has been idle for the amount of time specified.
MTU The Maximum Transmission Unit size may be changed if you want to
optimize efficiency for uploading data through the WAN interface. The
default setting (1400 bytes) should be suitable for most users. Some
user may want to adjust the setting to optimize performance for
wireless traffic or when low latency is desired (such as with Internet
gaming). It is highly recommended that the user research how
adjusting the MTU may affect network traffic for better or worse.
Connect mode select Select the desired option: Always on, Manual, or Connect on demand.
Most users will want to choose the default connection setting, Always
on.